27 - Driveline
06 - Semi-Automatic Gearbox
13 - Clutch - Master
27 - 131 9813/6850-2 27 - 131
5. Carefully lift off the cover and make sure that you
keep it square to the housing.
6. Make sure that you remove and discard all the
O-ring1 seals.
7. Remove the jacking bolt.
8. Remove and discard the cover O-ring seal.
9. Prise out and discard the oil seal2 carefully and
make sure that the seal housing in the cover is
not damaged.
10. Install the special locking plates to prevent the
clutch assembly from rotating.
Special Tool: Locking Plates (Qty.: 2)
Figure 572.
A Cover attaching bolts (x18) H Special screws
J Clutch assembly K Special locking plate
L Housing
11. Use the cover attaching bolts and the special
screws that are supplied with the locking plates,
to lock the clutch assembly to the housing.
12. Remove all the clutch drum bolts.
To Next Page
Loading...
