JCM GEN5 Quick Reference Guide

GEN5™ Printer
© 2017 JCM Global Corporation 4 Part No. 960-000194R_Rev. A
B EZEL O PERATION
Table 2 identifies the Front Bezel Display indications, which allow
you to determine the Printer Status from a distance.
D ISABLING /E NABLING THE P APER L OW S ENSOR
To disable or enable the Paper Low Sensor:
1. Create a Paper Out condition.
2. Create a Paper In Chute condition.
3. Press and hold the FEED button for three (3) seconds.
When the
Paper Low Sensor is enabled, the GREEN READY
LED flashes three (3) times. When the
Paper Low Sensor is
disabled, the RED FAULT LED flashes three (3) times.
GEN5 DIP S WITCH S ETTINGS
The GEN5 Printer has a bank of DIP Switches. The functionality of
the DIP Switch settings is determined by the Firmware loaded into
the GEN5 Printer.
Table 2 GEN5 Bezel Display Status Indicators
Bezel Display Status
Solid On Printer Idle and Ready
Slow Blink Paper Low or Printer Error
Fast Blink Ticket Printing/Ticket In Chute
OFF Printer Power Off
NOTE: For current DIP Switch settings, refer to the
Software Information Sheet for the Firmware version
installed in the GEN5 Printer.
GEN5_FlipBookRevA_v15.fm Page 4 Friday, June 30, 2017 9:20 AM

JCM GEN5 Specifications

General

Brand	JCM
Model	GEN5
Category	Printer
Language	English