IN CASE OF EMERGENCY 263
Jack And Tools
1. Open the liftgate.
2. Lift the access cover using the load floor
handle.
Load Floor Handle
3. Remove the fastener securing the spare
tire.
4. Remove the chocks.
5. Remove the jack and wheel bolt wrench.
6. Remove the spare tire.
Preparations For Jacking
1. Park the vehicle on a firm level surface as
far from the edge of the roadway as
possible. Avoid icy or slippery areas.
2. Turn on the Hazard Warning Flashers.
3. Apply the Electric Park Brake.
4. Place the gear selector into PARK (P)
(automatic transmission) or REVERSE (R)
(manual transmission).
5. Turn the ignition to the OFF position.
1 — Wheel Bolt Wrench
2 — Jack
3 — Emergency Funnel
4 — Wheel Chocks
5 — Screwdriver
6 — Emergency Allen Key
WARNING!
A loose tire or jack thrown forward in a colli-
sion or hard stop could endanger the occu-
pants of the vehicle. Always stow the jack
parts and the spare tire in the places pro-
vided. Have the deflated (flat) tire repaired or
replaced immediately.
WARNING!
Do not attempt to change a tire on the side of
the vehicle close to moving traffic. Pull far
enough off the road to avoid being hit when
operating the jack or changing the wheel.
6
20_BV_OM_EN_USC_t.book Page 263
To Next Page
Loading...
Need help?
General
