Jeep 2020 RENEGADE User Manual

320 SERVICING AND MAINTENANCE
 Clean and protect the painted parts by
applying protective waxes.
 Clean and protect polished metal parts by
applying protective waxes.
 Apply talcum powder to the front and rear
wiper blades and leave raised from the glass.
 Cover the vehicle with an appropriate cover
taking care not to damage the painted
surface by dragging across dirty surfaces. Do
not use plastic sheeting which will not allow
the evaporation of moisture present on the
surface of the vehicle.
 Inflate the tires at a pressure of +7.25 psi
(+50 kPa) higher than recommended on the
tire placard and check it periodically.
 Do not drain the engine cooling system.
 Whenever you leave the vehicle is stationary
for two weeks or more, idle the engine for
approximately five minutes with the air condi-
tioning system on and high fan speed. This
will ensure a proper lubrication of the system,
thus minimizing the possibility of damage to
the compressor when the vehicle is put back
into operation.
NOTE:
When the vehicle has not been started or driven
for at least 30 days, an Extended Park Start
Procedure is required to start the vehicle. Refer
to “Starting The Engine” in “Starting And Oper-
ating” for further information.
BODYWORK
Protection From Atmospheric Agents
Vehicle body care requirements vary according
to geographic locations and usage. Chemicals
that make roads passable in snow and ice and
those that are sprayed on trees and road
surfaces during other seasons are highly
corrosive to the metal in your vehicle. Outside
parking, which exposes your vehicle to airborne
contaminants, road surfaces on which the
vehicle is operated, extreme hot or cold weather
and other extreme conditions will have an
adverse effect on paint, metal trim, and
underbody protection.
The following maintenance recommendations
will enable you to obtain maximum benefit from
the corrosion resistance built into your vehicle.
What Causes Corrosion?
Corrosion is the result of deterioration or
removal of paint and protective coatings from
your vehicle.
The most common causes are:
 Road salt, dirt and moisture accumulation.
 Stone and gravel impact.
 Insects, tree sap and tar.
 Salt in the air near seacoast localities.
 Atmospheric fallout/industrial pollutants.
CAUTION!
Before removal of the positive and negative
terminals to the battery, wait at least a min-
ute with ignition switch in the OFF position
and close the drivers door. When reconnect-
ing the positive and negative terminals to the
battery be sure the ignition switch is in the
OFF position and the drivers door is closed.
20_BV_OM_EN_USC_t.book Page 320

Jeep 2020 RENEGADE Specifications

General

Brand	Jeep
Model	2020 RENEGADE
Category	Automobile
Language	English