Jeep UNIVERSAL CJ-2A - Page 203

N
REAR AXLE
10533
FIG. 246- BEARING PULLER ADAPTER AND
HOLDING RING FOR USE WITH ARBOR PRESS
1- Hol :ling Rin g
2- Adapter
FIG . 247-PINION BEARING INSTALLING SLEEVE
1- Sleeve
202
FIG. 248·- PULLING PINION SHAFT
INNER BEARING CUP
N -8 . Re moving Pi nion a nd Differentia l
C ase B ea ring s
To remove the differential case bearings and pinion
bearings Fig. 238, use Bearing Puller W-104-B
as shown in Fig. 245.
Use of the above pullers assures easy removal of
bearings without damage to cages or rollers as
pulling pressure is applied directly to the bearing
cone.
To install the inner pinion bearing on model 44
axle pmions use Installing Sleeve, Tool C-3095
model 27 ax le us e Tool W-262 as shown in Fig . 247.
FI G. 249- PULLING PINION SHAFT
OUTER BEARING CUP
N-9. Pi nion a nd Ring Gear Setting Gauge Se t
For correc t and easy adjustment of the drive pinion
use a Pinion and Rin g Gear Setting Gaug e Set
W-99- B. This set includes a tool with adapter to
remove and install pinion b earing c ups , a C-clam p
alignin g fixt ure that locks to the pinion shaf t an d
aligns a dial indicator which accurately measure s
the distance from the pinion head to the bottom of
the differentia l sid e carrier bore , master gaug e
blocks , an d a dial indicato r.
Each C-clamp aligning fixture is embossed wit h
its pa rt number; usage is as follows: