How to fix a Jensen Car Video System that will not turn on?
If your Jensen Car Video System won't turn on, it could be due to a few reasons. First, check that the red and yellow wires are properly connected and receiving the correct voltage (11~16VDC). Also, ensure the black wire is connected to ground. Finally, inspect the fuse on the unit and in your vehicle; if blown, replace it with a new one.
What to do if my Jensen CMM10 Car Video System has power but no sound?
If your Jensen Car Video System has power but no sound, start by checking all speaker wire connections, including the speakers themselves. If the connections are fine, the speakers might be blown and need replacing. Also, ensure that all bare speaker wires are insulated from each other and the chassis ground to prevent short circuits.
Why does my Jensen CMM10 keep blowing fuses?
If your Jensen Car Video System keeps blowing fuses, it could be due to a short circuit. Check the yellow and red wires to make sure they are not touching the chassis ground. Also, inspect the speaker wires to ensure they are not touching the chassis ground. Look for any pinched or shorted wires. Finally, verify that you are using a fuse with the correct rating for your unit.
What to do if my Jensen CMM10 Car Video System has audio but no video?
If your Jensen Car Video System has audio but no video, check the connections at the parking brake and apply the parking brake as described in the manual. Also, the video playback codec might not be supported; refer to the Media Codec Support section for compatible formats.
General| Bluetooth | Yes |
|---|---|
| SD Card Slot | Yes |
| AV Input | Yes |
| Digital Media Playback | Yes |
| Backup Camera Input | Yes |
| Steering Wheel Control Compatible | Yes |
| DIN Size | Double DIN |
| Touchscreen | Yes |
| Built-in DVD Player | No |
| AUX Input | Yes |
| FM Tuner | Yes |
| Wireless Headphones | No |
| Remote Control | Yes |
| Display Size | 10.1 inches |
| Resolution | 1024 x 600 |
To Next Page
