JWM10A
BASIC OPERATION
Power
Mode
Audio menu setting
System menu setting
Press the POWER/MODE button (3) to turn the unit on.
Press and hold the POWER/MODE button (3) to enter standby mode from unit on.
After unit turn on, press the POWER/MODE button (3) to cycle through available
modes and choose the desired mode.
Press the AUDIO/SETTING button (4) to choose the following audio menu list:
Sleep Mode
Liquid Crystal Display(LCD)Back Light
Ÿ Sleep: The Sleep Timer will automatically turn off the JWM10A in the
designated number of minutes. To set the Sleep Time, press To set the
Sleep Time, press VOLUME / repeatedly to change the sleep time from
0(off),15,30.45 or 60 minutes.
Ÿ Dimmer: Adjust the brightness of the LCD from "BRI 9" (brightest) to "BRI 0" (off).
NOTE: When subjected to cold temperatures for an extended period of time,
LCD panels will take longer to illuminate and the display visibility may slightly
decrease. Optimal LCD operation will return to normal when the temperature
increases to a normal range.
Setting the alarm
Setting the Bluetooth
Reset
Ÿ Alarm ON/OFF: Press VOLUME / to turn on and off the alarm. The "ALARM"
icon will show on the display.
Ÿ Press the VOLUME button (2) to adjust the hour or press the VOLUME
button (1) to adjust the minute.
Ÿ BT ON/OFF: Press the VOLUME / button to turn on and off the Bluetooth
function
Ÿ BT DEV (Locked/Unlocked, Disconnect/Connect, Delete) :View, lock and delete
from a list of previously paired mobile device models.
Ÿ BT PAIR: Press BAND/ENTER (7) to start pairing with a Bluetooth enabled
device.
Ÿ Preset Volume (PVOL): Select an automatic turn on volume.
RESET: Press BAND/ENTER button (7) reset the to factory default settings. This
function will time out after 5 seconds of inactivity and the unit will resume normal
operation.
Ÿ BAS: Adjust the Bass level from "-7" to "+7".
Ÿ TRE: Adjust the treble from "-7" to "+7".
Ÿ BAL: Adjust the speaker output balance between "L7" (left) and "R7" (right).
"BAL 0" indicates an equal balance between the left and right speakers.
Ÿ LOUD: Toggle the loudness on/off. When listening to music at low volumes,
this feature will boost the bass/treble ranges to compensate for the
characteristics of human hearing.
Ÿ Use the VOLUME / to make adjustments in each menu item.
Press and hold the AUDIO/SETTING button to enter system menu list and press
AUDIO/SETTING once again to choose the following system menu list:
Volume control
Press the VOLUME to increase the volume output. Press and hold the
VOLUME to increase the volume output continuously.
Press the VOLUME to decrease the volume output. Press and hold the
VOLUME to decrease the volume output continuously.
Audio Adjustment
6
1
2
3
4
5
6
7
8 9
10
11
12
13 14 15
H M
Auxiliary Input Function
When a portable audio device is connected to the unit, press the
POWER/MODE button(3) repeatedly until AUX 1/ AUX 2 mode is
selectable. To connect a portable audio device, insert a standard 3.5mm(audio line
output or headphone output from your portable CD/MP3 iPod or other media) into the
AUX IN connector(6) on the front of the unit or the AUX-IN RCA jack(AUX AUDIO
INPUT) on the rear of the unit.
M
M
H
H
H
M
To Next Page
Loading...
