Wiring Diagram
CAUTION! IMPORTANT: Incorrect wiring connections can damage the unit. Follow the wiring instructions carefully,
or have the installation handled by an experienced technician.
Need Help? For technical assistance, call the Jensen customer support line at 1-800-323-4815.
The VX3010 has a built-in SWC Interface compatible with most resistive type OE steering wheel controls. In most installations, only two of the three wires will be needed to
interface the OE steering wheel controls to the VX3010.
SWC A - Primary SWC Wire
SWC B - Secondary SWC Wire
SWC Ground - Chassis ground
Initial wiring of the SWC interface should include the SWC A and SWC Ground wire. If this combination of wiring does not support your vehicle functions, then try the SWC B
and SWC Ground wire combination. Do not use only SWC A and SWC B. The SWC Ground must be connected.
Some vehicles may not support all SWC functions. Professional Installation is recommended.
2
YELLOW
SWC Adapter Cable
PARK
VIDEO OUT
BLACK
ANT
AUTO ANTENNA
MONITOR
BACKUP
CAMERA
BATTERY
GND
AUX2 R
AUX2 L
AUX2 VIDEO IN
BLUE/WHITE
AMP. TURN ON
REVERSE
BATTERY
GND
SWC GND
SWC B
SWC A
External Microphone
Microphone
BACKUP CAMERA
YELLOW
BATTERY(+)
GND(-)
ACC+
BRAKE INDICATION
PARKING BRAKE SWITCH
POWER AMPLIFIER
IGNITION SWITCH
GND
SIGNAL LIGHT
REVERSE DRIVING
GEAR
White/Purple
White/Brown
Brown/Black
White/Purple
White/Brown
Brown/Black
GREEN/WHITE
MOBILE POWER AMP
BLUE - Power Antenna
ORANGE - Dimmer TFT
128-9271 VX3010 Installation Guide 01-16-14.indd 4 1/16/2014 1:29:56 PM
To Next Page
Loading...
Need help?
General
