Why does my Jensen VX3012 Car Receiver reset when the engine is off?
If your Jensen Car Receiver resets itself when the engine is off, it could be due to an incorrect connection between the ACC and BATT wires. Check the wiring and correct it.
How to remove constant warning message on Jensen VX3012 Car Receiver?
If warning information is constantly displayed on your Jensen Car Receiver, it's likely due to incorrect parking brake wiring. Check the wiring and correct it.
Why is there no sound coming from my Jensen Car Receiver?
If you're experiencing no or low audio output from your Jensen Car Receiver, several factors could be the cause. First, check the audio output connections to ensure they are properly wired. Also, verify that the volume isn't set too low; increase it as needed. Damaged speakers can also cause this issue, so consider replacing them. Heavily biased volume balance can lead to low output, adjust the channel balance to the center position. Finally, ensure that the speaker wiring isn't in contact with any metal parts of the car, as this can cause interference. Insulate all speaker wiring connections to resolve this.
What to do if my Jensen VX3012 won't turn on?
If your Jensen Car Receiver isn't powering on, there are a few potential reasons. The unit fuse or the car battery fuse may have blown; in either case, install a new fuse with the correct rating. It is also possible that the unit is in illegal operation mode, in this case you should reset the unit.
How to fix poor sound quality on Jensen VX3012?
If you're experiencing poor sound quality or distortion with your Jensen Car Receiver, consider these potential causes. Using a pirate disc can result in sound issues, so switch to an original disc. Mismatched speaker power ratings can also lead to distortion, so replace the speakers if necessary. Check the wiring and correct any wrong or shorted connections.
Why is my Jensen VX3012 remote not working?
If the remote control for your Jensen Car Receiver isn't working, the battery may be depleted; try changing the battery. Also, ensure that the battery is installed correctly.
What to do if the Jensen Car Receiver screen is flashing?
If you observe a flashing image or interference on the screen of your Jensen Car Receiver, the issue might be due to the use of a pirate disc; try using an original disc instead. The video cable could also be damaged, so replace the cables. Check the video signal connections and correct them if they are improper.
General| Receiver type | - |
|---|---|
| Audio output channels | - channels |
| Power output per channel (20-20KHz@8 Ohm) | - W |
| USB ports quantity | 1 |
| Connectivity technology | Wired & Wireless |
| Bluetooth | Yes |
| Optical drive type | DVD player |
| Display | TFT |
| Product color | Black |
| Handheld remote control | No |
Weight and Dimensions| Width | - mm |
|---|
Controls unit power and accesses the main source menu.
Adjusts volume and mutes audio output.
Navigates tracks or seeks radio stations.
Receives command signals from the remote control.
Protects the USB and AV interface connectors.
Resets system settings to correct operation halts.
Port for connecting compatible A/V devices.
Opens, closes, and adjusts the TFT display angle.
Shows playback information or alternate LCD display.
Ejects the inserted DVD/CD/MP3 disc.
Slot for inserting DVD/CD/MP3 discs.
Switches between and selects available audio/video sources.
Ejects the inserted DVD/CD/MP3 disc.
Selects the audio language for DVD playback.
Increases or decreases the playback volume.
Scrolls preset stations or controls playback speed.
Controls track or disc repeat playback modes.
Turns the audio output ON and OFF.
Turns the unit ON and OFF.
Selects the subtitle language for DVD playback.
Accesses the root menu of a DVD or CD.
Advances playback speed or tunes radio frequency.
Skips to the next track or tunes radio frequency.
Pauses or resumes playback.
Returns to the previous track or tunes radio frequency.
Reverses playback speed or tunes radio frequency.
Directly access tracks, chapters, or radio presets.
Plays tracks or chapters in random order.
Instructions for powering the unit on and off.
Navigating the main menu to select sources.
Controls for muting audio and adjusting volume levels.
Opening, closing, and adjusting the TFT display angle.
Procedures for soft and hard system resets.
Adjusting video aspect ratio and image parameters.
Adjusting audio EQ presets, balance, and fade.
Disc playback initiation and parking brake video inhibit.
Configuring radio region, beep, demo modes, and range.
Procedure for calibrating the touch screen interface.
Adjusting aspect ratio and rear camera display settings.
Setting date, clock mode, and time format.
Configuring subwoofer and loudness settings.
Selecting OSD, DVD audio, subtitle, and menu languages.
Configuring Bluetooth function, auto-connect, and answer.
Setting parental control password and rating levels.
Setting relative volume levels for different sources.
Choosing between FM1, FM2, FM3, AM1, and AM2 bands.
Methods for seeking and manually tuning radio stations.
Storing and recalling radio stations using presets.
Automatically stores stations and selects local/distant signals.
Configuring equalizer, RDS, clock time, and program type.
Lists supported disc formats like DVD, CD, MP3.
Main menu navigation, disc insertion, and touch controls.
Steps for connecting and initiating playback from a USB device.
Basic controls for managing audio and video playback.
Skipping tracks/chapters and searching for files/folders.
Playing video and picture files from discs or USB.
Utilizing repeat modes and random track playback.
VCD-specific playback control features.
Selecting audio modes, subtitle languages, and viewing angles.
Adjusting video settings and viewing playback details.
Displaying VCD track info and playback time.
Selecting tracks directly, rotating, and zooming pictures.
Fine-tuning audio balance, fader, and subwoofer levels.
Connecting and navigating the iPod/iPhone interface.
Controls for pausing, selecting, and fast forwarding tracks.
Managing repeat playback modes and random track selection.
Procedure for disconnecting a paired Bluetooth device.
Synchronizing contacts and managing call logs.
Handling incoming calls, manual or automatic.
Configuring Bluetooth, auto-connect, and pairing codes.
Accessing Siri or Google Voice via Bluetooth.
Streaming music using A2DP and controlling playback via AVRCP.
Compatibility with steering wheel control interfaces.
Guidelines for installing and programming the SWI-RC module.
Resolving issues with power, remote control, and audio output.
Addressing problems with warning information and screen interference.
Solutions for discs that cannot be inserted or played.
Interpreting and resolving common error messages.
To Next Page
