To Next PageTo Next PageWhy does my Jensen VX4020 keep resetting itself?
If your Jensen Car Receiver resets itself when the engine is off, it is likely due to an incorrect connection between the ACC and the positive battery wire. Check the wiring and correct it.
Why is there no sound coming from my Jensen VX4020?
If you're experiencing no or low audio output from your Jensen Car Receiver, there might be several reasons: * Improper audio output connection: Check the wiring and correct any issues. * Volume set too low: Increase the volume level. * Improper “MUTE” connection: Review the wiring diagram and check the “MUTE” connection. * Speakers damaged: Replace the speakers. * Heavily biased volume balance: Adjust the channel balance to the center position. * Speaker wiring is in contact with a metal part of the car: Insulate all speaker wiring connections.
How to fix a Jensen VX4020 that won't turn on?
If your Jensen Car Receiver will not power on, it could be due to a few reasons: * A blown radio fuse: Replace the fuse with a new one of the correct rating. * A blown car battery fuse: Replace the fuse with a new one of the correct rating. * Illegal operation: Press the RESET button located in the middle of the left side of the front panel.
What to do if my Jensen VX4020 Car Receiver has poor sound quality?
Poor sound quality or distortion in your Jensen Car Receiver can stem from a few causes: * Using a pirated disc: Use an original copy of the disc. * Speakers not compatible with the unit: Connect proper speakers. * Shorted speaker: Check the speaker contact.
General| Bluetooth | Yes |
|---|---|
| USB Ports | 1 |
| Touchscreen | Yes |
| SD Card Input | Yes |
| Rear Camera Input | Yes |
| Steering Wheel Control Compatible | Yes |
| AM/FM Tuner | Yes |
| Auxiliary Input | Yes |
| Remote Control | Yes |
| Display Type | LCD |
| Audio Formats Supported | MP3, WMA |
| Video Formats Supported | MPEG-4 |
| Preamp Outputs | Front, Rear, Subwoofer |
| Power Output | 200 Watts (50 Watts x 4 Channels) |
