EasyManuals Logo

Jerr-Dan MPL40 User Manual

Jerr-Dan MPL40
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
Section I: Safety
Page 4
5-376-000086
REV. 4 - 07/10
NOTE
These ratings apply to the structural design of the Standard Duty Carrier only
and may be limited by the axle rating and gross vehicle weight rating of the truck
chassis.
The payload and towing capacity of any towing vehicle must meet the
following:
- The actual payload on the towing vehicle must not exceed the posted
rating and, if applicable, the towed vehicle load must not exceed
the posted lift / towing ratings.
- The total weight of the towing vehicle (cab chassis, body, payload,
driver, passenger(s), tools, fuel, etc.) and, if applicable, the towed
vehicle load must not exceed the GVWR (Gross Vehicle Weight Rating)
of the towing vehicle.
- The total weight of the towing vehicle and, if applicable, the towed
vehicle load must be distributed so that each axle’s GAWR (Gross Axle
Weight Rating) is not exceeded.
- The total weight of the towing vehicle and towed vehicle (everything
that moves with the towing vehicle) must not exceed the GCWR
(Gross Combination Weight Rating) of the towing vehicle.
Staying within these ratings is necessary to maintain the safety and
performance of the towing vehicle.
CHECK TRUCK MANUAL FOR SPECIFIC GVW & AXLE RATINGS. ALSO
REFERENCE THE CERTIFICATION DECAL AFFIXED TO DRIVER’S SIDE DOOR
JAMB, HINGE PILLAR OR LATCH POST AND THE S.T.A.R. PLACARD ON THE
DRIVER'S SIDE OF THE HEADBOARD.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jerr-Dan MPL40 and is the answer not in the manual?

Jerr-Dan MPL40 Specifications

General IconGeneral
BrandJerr-Dan
ModelMPL40
CategoryUtility Vehicle
LanguageEnglish