Section II: Operation
Page 66
5-376-000086
REV. 4 - 07/10
3. After you have the latch open, the
dolly is free to be removed.
4. Remove the dolly wheel
assemblies, the axle cross tube
rails and the pry bar/jack bar.
5. Load dollies. (See Dolly
Operation instructions).
6. Afterloading the dollies, place the
pry bar/jack bar back into the
storage bracket by inserting the
end of the bar with the ring around
it thru the cutout in the front
bracket. Allow the other end of
the bar to rest on the rear bracket.
To Next Page
Loading...