EasyManua.ls Logo

Jerr-Dan MPL40 - Dolly Operation - Securing and Unloading

Jerr-Dan MPL40
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Section II: Operation
Page 71
5-376-000086
REV. 4 - 07/10
11. Safety tie-down straps should be used to secure dolly to vehicle in
case of rough road. Dolly is now ready for towing.
BE SURE EACH WHEEL IS SECURELY HELD IN ITS DOLLY AND
INSPECT THE GROUND CLEARANCE OF THE VEHICLE BEFORE
ATTEMPTING A TOW.
To unload the vehicle, stand clear of both the vehicle and the dollies and slip
the chain link off of the cam bar. Carefully slide the jack handle over the
cam bar and slowly lift the handle allowing the vehicle to drop. Repeat this
step on the other dolly and then remove the axles from the dollies.
USE CARE WHEN RELEASING OR UNLOCKING THE CAM BAR AS IT
CAN MOVE SUDDENLY AND WITH FORCE, CAUSING INJURY. JERR-
DAN ASSUMES NO LIABILITY FOR THE USE OR MISUSE OF THESE
DOLLIES OR ANY DAMAGE CAUSED BY THEM.