28
SPEED CONTROLS (Standard lathes)
SPINDLE ROTATION
Selected by the controls lever-A (Fig.10). The apron gated
lever-A for Forward-off-Reverse selections.
After started the main motor running, to move gate lever-A
out and downward to engage forward rotation of spindle; or
upward to engage reverse rotation. Return to netural
position for spindle stop.
FOOTBRAKE
A foot pedal located between machine base plinths
operates the spindle brake and cut off the power to the
drive motor. After the foot-brake is applied, the lever-A
should be returned to the neutral position to re-start the
spindle rotation.
WARNING: NEVER SHIFT SPEED CONTROL LEVERS B&C
AND FEED LEVERS D&E ON THE HEADSTOCK WHILE THE
SPINDLE IS ROTATING. RECOMAND TO PRESS THE
JOGGING BUTTON ON PANEL FOR HELPFUL THE LEVER
CHANGES.
Fig10
To Next Page
Loading...