Jester Operating Manual Super User Mode
32 of 52 Jester Manual 73-403-00 Issue 3.2
programmed, edited or cleared. Additionally no Super User options (such as
changing the DMX Patch) can be performed while the desk is locked. It is still
however possible to replay memories, submasters and auxiliaries normally.
To lock/unlock the desk, select <Lock/Unlock>, and press ENTER.
If the desk is unlocked, you must now enter the lock code using the Submaster Flash
buttons and press ENTER. The default lock code for the Jester is 0000. Once the
correct lock code has been entered, you will be presented with 2 options:
Lock Desk
To lock the desk and prevent any changes to the recorded data, select <Lock
Desk>, press ENTER. The desk is now locked, and you will be returned to the
Super User menu.
Change Code
It is recommended that you change the lock code from the default to something
that you will be able to easily remember. To do this, select <Change Code>,
press ENTER, then type in the new code using the Submaster Flash buttons and
press ENTER again. You will be returned to the Super User menu.
If the desk is locked, then you will be prompted to enter the 4 digit unlock code, using
the Submaster Flash buttons. If this is entered correctly then the desk will be
unlocked and you will be returned to the Super User menu. Changes to the recorded
data can now be made as normal.
If you forget the lock code for your Jester, please contact Zero 88 Technical Support
for assistance, and have the desk’s serial number to hand. You may be asked some
questions to verify your identity and ensure that you have genuine reason to unlock a
desk without knowing it’s lock code.
Clear Mems/Subs
If you wish to clear the memories and submasters, select <Clear Mems/Subs>.
Press ENTER and the desk will ask you to confirm whether you wish to clear these
areas of the desk. Use the cursor keys to select <OK>, and press ENTER. The
memories and submasters will be cleared, and you will be returned to the Super User
menu.
Reset Desk
If you wish to clear all settings and the DMX patch, and return the desk to its factory
settings, use the cursor keys to select <Reset Desk>. Press ENTER. The desk will
ask you to confirm the action – use the cursor keys to select <OK>, and press
ENTER. The desk will be returned to factory defaults, and you will be returned to the
main Super User menu.
To Next Page
Loading...
Need help?
General