1 888 275 4538 MVP GROUP .15 | P a g e
All dishwashers are pre-set for electrical connection of external automatic detergent pump or automatic
detergent pump kit through the injector and related tube or by the hole located on the back tank of the
machine. If required only the models supplied by Jet-Tech will be accepted.
THIS MODIFICATION, IF REQUIRED, MUST BE CARRIED OUT BY QUALIFIED TECHNICIAN ONLY.
3B3 – WASHING CYCLE
The wash cycle includes one wash with hot water and detergent at 60°C (140°F) and one rinse cycle with hot
water and rinse aid at 85°C (185°F). When the machine reaches the correct temperature and it is ready to
start a new cycle, the button “D” will become GREEN then:
1- Open the door.
2- Add recommended quantity of detergent inside the tank – only models without automatic dispenser
included – (see par. 3B2)
3- Insert dirty dishes loaded in the basket and close the door.
4- Press one of the available cycles between button “A”, “B”, ”C” or “G”. (Fig.15)
Fig.15
5- Press button “D” to start the wash cycle. (Fig.16)
Fig.16
6- Wait until is displayed “END” cycle finished, open the door and remove the basket with the clean dishes.
(Fig.17)
Fig.17
To Next Page
Loading...
