2
Make sure the lathe is properly grounded.
Power is connected properly when pulling up
on the forward-reverse lever causes the
spindle to rotate counter-clockwise as viewed
from the tailstock. If the chuck rotates in the
clockwise direction, disconnect the lathe from
the power source, switch two of three power
leads (for GH-1340W-3 & GH1440W-3), and
connect the lathe to the power source.
To Switch from 230V to 460V Operation
GH-1340W-3 & GH1440W-3 Only
î
WARNING
Disconnect the machine from the power
source!
Failure to do so may cause serious injury!
Main Motor: Change the wires according to
the diagram on the inside of the motor junction
box.
Transformer: Remove electrial panel on rear
of the machine, headstock side, switch wire
from 230V terminal to 460V terminal as
outlined on the transformer.
Coolant Pump: Open access panel on the
base at the tailstock end. Change wires in
coolant pump junction box according to
diagram on the inside of the junction box
cover.
To Next Page
Loading...
Need help?
General
