6
5.0 Specifications
Model number
IBG-8VSB
Stock number 578218
Motor and Electricals
Motor type TEFC induction with inverter
Horsepower (true output) 1
Motor phase 3
Voltage 115/230V (prewired 115V)
Input power
single phase
Cycle 60 Hz
Listed FLA (full load amps) 7 / 3.5 A
On/off switch TACT switch
Motor speed Variable, 900-3600 RPM
Power cable size 16AWG x 3C SJT, 6 ft. (182 cm)
Power plug installed 5-15P, 125V/15A
Recommended circuit size
1
15A
Sound emission without load
2
75 dB at 3 ft.
Arbor and buffing wheels
Arbor diameter 5/8 in. (16mm)
Wheel size (OD x width) 8 x 1/2 in. (203.2 x 12.7mm)
Wheel bore 5/8 in. (16mm)
Wheel material Woven cotton: spiral sewn and half-spiral sewn
Wheel flange diameter 3-3/8 in. (85mm)
Wheel speed Variable, 900-3600 RPM
Main materials
Arbor Steel
Base Cast iron
Motor housing Sheet metal
End cover Aluminum
Flange washers Cast iron
Dimensions
Mounting hole centers 8-1/2 in. (215mm)
Mounting hole diameters 7/16 in. (11mm)
Footprint (width x depth) 9-1/2 x 8-1/16 in. (241.6 x 205 mm)
Assembled dimensions (LxWxH) 23-1/2 x 8 x 10-9/16 in. (590 x 205 x 268 mm)
Shipping dimensions (LxWxH) 25-1/2 x 10-5/16 x 11-5/16 in. (648 x 262 x 288 mm)
Weights
Net weight 40 lb (18.33 kg)
Shipping weight 44 lb (20.20 kg)
1
subject to local/national electrical codes.
2
The specified values are emission levels and are not necessarily to be seen as safe operating levels. As workplace
conditions vary, this information is intended to allow the user to make a better estimation of the hazards and risks
involved only.
L = length, W = width, H = height
n/a = not applicable
The specifications in this manual were current at time of publication, but because of our policy of continuous
improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring
obligations.
To Next Page
Loading...
