Why is the spindle on my Jet Power Tool so noisy?
A noisy spindle on your Jet Power Tool could indicate damaged spindle bearings, in which case you should replace the bearings. Another possible cause is a worn spline, which should also be replaced.
What causes no speed readout on my Jet Power Tool?
A lack of speed readout on your Jet Power Tool could be due to a speed pickup that is out of adjustment or has failed. Try adjusting the gap between the speed pickup and the post spindle pulley. If there is still no readout, replace the speed pickup.
Why the table can not be raised on my Jet Power Tool?
If the table on your Jet Power Tool cannot be raised, it may be due to a lack of lubrication. Lubricate the necessary parts.
General| Brand | Jet |
|---|---|
| Model | J-A3816 |
| Category | Power Tool |
| Language | English |
To Next Page
