To Next Page

To Previous Page

Introduction

This manual is provided by Walter Meier (Manufacturing) Inc., covering the safe operation and maintenance

procedures for a JET Model JBOS-5 Oscillating Spindle Sander. This manual contains instructions on

installation, safety precautions, general operating procedures, maintenance instructions and parts breakdown.

This machine has been designed and constructed to provide years of trouble free operation if used in

accordance with instructions set forth in this manual. If there are any questions or comments, please contact

either your local supplier or Walter Meier. Walter Meier can also be reached at our web site:

www.waltermeier.com.

Specifications

Model Number ............................................................................................................................................ JBOS-5

Stock Number ............................................................................................................................................. 708404

Table Size (in.) ................................................................................................................................ 14-1/2 x 14-1/2

Table Tilt (deg.) .................................................................................................................................. 0 to 45 down

Height, without spindle (in.) ........................................................................................................................... 18-3/4

Base Footprint (in.) .......................................................................................................................... 11-3/4 x 11-3/4

Spindle Speed (RPM) .................................................................................................................................... 1,725

Oscillations per Minute ........................................................................................................................................ 30

Maximum Length of Oscillation (in.) ...................................................................................................................... 1

Oscillation Gear Environment .......................................................................................................... sealed oil bath

Dust Port outside diameter (in.) ............................................................................................................................ 2

Power Cord length (ft.) .................................................................................................................................... 5-1/2

Motor (TEFC) ............................................................................. TEFC Induction, 1/2 HP, 1PH, 110V, 60Hz, 7.5A

Switch ............................................................................................................... manual, with removable safety key

Net Weight (lb) .................................................................................................................................................... 77

Shipping Weight (lb) ............................................................................................................................................ 82

The above specifications were current at the time this manual was published, but because of our policy of

continuous improvement, Walter Meier reserves the right to change specifications at any time and without prior

notice, without incurring obligations.