Why does my Jet JDS-12B Sander leave sanding marks on wood?
If your Jet Sander leaves sanding marks on the wood, make sure to keep the workpiece moving and avoid holding it still. Use a coarser grit sanding disc for stock removal and a fine grit for finish sanding. Never force the workpiece and always sand with the grain.
What to do if my Jet JDS-12B Sander will not start?
If your Jet Sander won't start, check all plug connections to ensure the sander is properly plugged into the wall or motor. Replace the fuse or reset the circuit breaker if it has blown or tripped. If the cord is damaged, replace it.
Why sanding disc does not come up to speed on my Jet JDS-12B Sander?
If the sanding disc on your Jet Sander does not come up to speed, the extension cord may be too light or too long; replace it with an adequate size and length cord. If there's low current, contact a qualified electrician.
How to reduce excessive vibration in my Jet Sander?
If your Jet Sander machine vibrates excessively, adjust the stand or base so that it rests evenly on the floor. Also, bolt down the machine.
What to do if sanded edge not square with Jet JDS-12B Sander?
If the sanded edge is not square when using your Jet Sander, use a square to adjust the table to the sanding disc.
Information on new products and up-to-date product details available via distributors.
Details the 1-year limited warranty, exclusions, limitations, and legal rights.
Details 115V operation, plug compatibility, and adapter use for grounding.
Instructions for converting and operating the sander on 230V power.
Lists all items included in the sander's packaging.
Lists necessary tools for assembly and adjustments.
Instructions for safely unpacking the sander and reporting any damage.
Step-by-step instructions for removing and replacing the sanding disc.
Guide on using the center point for sanding circles.
Instructions for securing and using the filler bar for small workpieces.
How to use the brake to slow or stop the sanding disc.
Details on operating the power switch and removing the safety key.
Guidance on lubricating moving parts for smooth operation.
Instructions for keeping the motor clean and ensuring proper ventilation.
Information on connecting the sander to dust collection systems.
Steps for installing and grounding the optional canister filter.
Procedures for effectively cleaning the canister filter.
Possible causes and solutions for the sander failing to start.
Solutions for the sanding disc not reaching proper speed.
Causes and remedies for excessive machine vibration.
How to address an unsquare sanded edge.
Tips for achieving smooth sanding marks and avoiding issues.
Diagram showing the wiring for 115V operation.
Diagram showing the wiring for 230V operation.
General| Type | Disc Sander |
|---|---|
| Weight | 71 lbs |
| Prewired Voltage | 115V |
| Sandpaper Size | 12 inches |
| Disc Diameter | 12 inches |
| Phase | 1 |
| Sanding disc diameter | 12 inches |
| Disc Speed | 1720 RPM |
| No-load speed | 1720 RPM |
To Next Page
