Why does the drum motor on my Jet JWDS-1020 overheat?
The drum motor on your Jet Sander may overheat if air circulation through the motor is restricted. Clean the motor fan with compressed air to restore normal air circulation. The motor might also be overloaded due to an excess feed rate or depth of cut. Reduce the conveyor speed and/or depth of cut to prevent overheating.
What causes a line or groove in the stock when using my Jet JWDS-1020 Sander?
A line or groove in the stock when using your Jet Sander is caused by an inconsistent feed rate. To avoid this, do not stop or change the feed rate while feeding stock.
Understand manual, use trained personnel, and follow intended use guidelines.
Wear safety gear, secure attire, use hearing protection, and maintain a clean work area.
Ensure grounding, unplug for adjustments, keep guards, check parts, and remove keys.
Critical steps for properly attaching abrasive strips to the drum.
Mandatory grounding procedures for safe electrical operation.
Step-by-step guide for performing basic sanding operations.
To Next Page
General
