5. Now the ECU can memorize the positions of the throttle and AUX channels. First,
place the throttle stick and throttle trim to low. Next, press Select Menu or the LED
I/O board switch, again. This will store the R/C system’s pulse width for immediate
shutdown of the turbine. The green OK LED will turn off and the red Pump running
LED will illuminate. This indicates that the shutdown data has been set correctly.
The GSU display will read:
Æ Throttle channel “Idle” position
Throttle Trim to
maximum:
6. Advance the throttle trim lever to maximum. Press Select Menu or the LED I/O
board switch again, to store the R/C system’s pulse width for the turbine idle position.
The red Pump running LED will turn off and the yellow Standby LED will illuminate.
This indicates that the turbine idle data has been set correctly.
The GSU display will read:
Æ Throttle channel “Full Power” position
Set Throttle to
maximum:
7. Advance the throttle stick to maximum. Press Select Menu or the LED I/O board
switch again, to store the R/C system’s pulse width for the turbine full power position.
The yellow Standby LED will turn off and the green OK LED will illuminate again,
indicating that the turbine full power data has been set correctly. This completes the
learn mode for throttle and initiates the learn mode for the three-position AUX
channel.
The GSU display will now read:
Æ AUX channel minimum “Off” position.
Set AuxChan. to
minimum:
8. Move the AUX channel to the minimum position for Off and press Select Menu or
the LED I/O board switch again, to store the R/C system’s pulse width for immediate
shutdown of the turbine. The green OK LED will turn off and the red Pump running
LED will illuminate. This indicates that turbine shutdown data has been set correctly.
Page 34/74
To Next Page
Loading...