Suggestions for starting a multi-engine plane using StartUp Mode
In two channel mode->
Place one ECU in SEQUENCE mode and the other in THROTTLE MAX mode. By
moving the throttle trim to maximum and the throttle stick to maximum, start the engine
in THROTTLE MAX mode by switching the AUX control to the center START/RUN
position. The engine in SEQUENCE mode is then started by moving the throttle stick to
the minimum position and then back to the maximum position.
In single channel mode->
Place one ECU in SEQUENCE mode and the other in IMMEDIATE mode. First have
both the throttle trim and stick at their minimum positions. Then by moving the throttle
trim to the maximum position will start the engine in IMMEDIATE mode. The engine in
SEQUENCE mode is then started by moving the throttle stick to the maximum position.
Page 53/74
To Next Page
Loading...