JETI model Duplex DS-12 User Manual

computer radio control system
EN
3. Reconnect transmitter battery pack and reinstall radio back
cover and cover screws.
By turning the screw clockwise, you will tighten spring tension. As
a result the moving resistance of the control stick will increase.
2. Use indicated machine adjustment screws to change the
desired spring tension. By turning the screw countercloc
kwise, you will loosen spring tension. As a result the moving
resistance of the control stick will decrease.
2
2
1. Switch off the transmitter and remove the 7 screws that secure
the radio back cover. Next, remove the radio back cover. Be sure
to disconnect the transmitter battery pack connector.
2. For ratchet tension adjustment use the machine screw . “A”
Turn slowly (counter-clockwise) until you achieve the desired
ratchet tension. For smooth tension adjustment, use the
machine screw Turn slowly (clockwise) until you achieve “B”.
the desired smooth tension.
4.3.4 Ratchet Tension Adjustment
Whether you prefer smooth throttle feel or ratchet throttle feel, you
can adjust the DS-12 transmitter either way you like allowing you to
fully customize your radio‘s feel. Each tension is set by a different
machine screw.
A
B
3. Reconnect transmitter battery pack and reinstall radio back
cover and cover screws.
18

JETI model Duplex DS-12 Specifications

General

Brand	JETI model
Model	Duplex DS-12
Category	Remote Control
Language	English