EasyManua.ls Logo

JETI model Duplex DS-12 - Transmitter Handling and SD Card Management; Transmitter Handling; Changing the SD Card

JETI model Duplex DS-12
60 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
computer radio control system
EN
4.8 Handling
The DS-12 is equipped with a handle for practical manipulation as
shown in the picture.
Before each flying session, and especially with a
new model, it's important to perform a range
check. If you are operating a model with a DS-12
transmitter do not shield and avoid contact of the
transmitter antennas (see Photo)with your body.
Warning:
The transmitter 2.4GHz antenna locations are shown in the picture
below.
4.9 Change SD Card
Disconnect the battery plug .
To open the SD card holder, use a fingernail to push the metal frame
to the right and then lift it carefully . The micro SD card can now be
removed . For installation, proceed in the reverse order .
[
25

Table of Contents

Related product manuals