JETI model Central Box 200 - User Manual

EN
1. Introduction ..................................................................................... 2 EN
1.1 Attributes ................................................................................... 3 EN
2. Description ........................................................................................ 3 EN
2.1 Central Box 200 ....................................................................... 3 EN
2.2. Central Box 100 ....................................................................... 5 EN
2.3 Magnetic switch ( Central Box 200 only) ............................ 6 EN
3. Connection ...................................................................................... 7 EN
3.1 Power Supply ............................................................................ 7 EN
3.2 Overload protection of servos ............................................ 10 EN
3.3 Connecting Central Box – PPM variant ............................ 11 EN
3.4 Connecting Central Box – EX Bus variant ........................ 12 EN
4. Configuration via JETIBOX ....................................................... 14 EN
4.1 Actual values .......................................................................... 15 EN
4.2 Minimum / Maximum values ............................................. 15 EN
4.3 Setting ..................................................................................... 16 EN
4.4 Out Pin Set ............................................................................... 17 EN
4.5 Alarms .................................................................................... 18 EN
4.6 Service information .............................................................. 19 EN
5. Configuration via the DC/DS transmitter ............................. 20 EN
5.1 General Settings .................................................................... 21 EN
5.2 Fail-Safe .................................................................................. 22 EN
5.3 Servo Output Mapping ....................................................... 23 EN
5.4 Telemetry ............................................................................... 23 EN
5.5 Telemetry Min/Max .............................................................. 24 EN
5.6 Reset to factory settings ...................................................... 24 EN
6. Firmware update ........................................................................... 25 EN
7. Safety precautions for working with magnets ................... 26 EN
8. Technical specifications of the Central Box .......................... 27 EN
9. Warranty, service and the technical support ....................... 28 EN
1 EN

Summary

Central Box Connection Guide

Power Supply Connection

Describes how to connect power sources, including battery requirements and connector types.

Servo Overload Protection

Explains the servo output overload protection mechanism and its function.

Connecting Central Box with PPM Variant

Connecting Central Box with EX Bus Variant

Configuration via JETIBOX

JETIBOX Settings

Covers basic device settings, including Fail Safe, Signal Fault Delay, and Output Period.

Output Pin Settings

Guides on setting output pins, functions, input channels, and signal fault behavior.

Alarms Configuration

Configuration via DC;DS Transmitter

General Settings via Transmitter

Covers general settings like output period, expander settings, and shutdown voltage.

Fail-Safe Settings

Explains the Fail-Safe function, delay, and mode settings for individual outputs.

Servo Output Mapping

Telemetry Data

Telemetry Min;Max Values

Reset to Factory Settings

Firmware Update Procedure

Safety Precautions for Magnets

Technical Specifications

JETI model Central Box 200 Specifications

General

Weight	120 g
Number of Channels	16
Telemetry	Yes
Supported Protocols	JETI Duplex
Input Voltage	4.8V - 8.4V
Compatibility	JETI Duplex
Operating Temperature	-10°C to +60°C