JETI model Central Box 200 - Connecting Central Box with EX Bus Variant

EN
RC Switch Magnetic Switch
Input Voltage
SERVO
Rsat2 (Rx1)
SERVO
Rsat2 (Rx2)
SERVO/Sensor
input voltage
4-14V
Fig. 10: Block diagram of Central Box 200 connection - PPM variant
3.4 Connecting Central Box – EX Bus variant
Receivers can be connected to the Central Box using the Rx1 and
Rx2 inputs.
Ext1 is an input for telemetry sensor. Telemetry is transmitted to the
receivers via EX Bus.
Channels 14 and 15 can be configured as servo outputs or as
inputs for connecting telemetry sensors ( Central Box 200 only).
Configuring the Central Box is in this case done directly in the
transmitter via EX Bus.
When operating the Central Box with DC/DS transmitter, it is
recommended to use two receivers communicating with the
transmitter in the wireless mode "Double path".
12 EN
PPM
PPM
Ext.