JetLegend T-45 Goshawk User Manual

JetLegend T-45 Goshawk
Page 10 of 24
24 There are three faint marks molded into
the bottom of the flaps. Highlight them with a
marker.
25 Cut and drill out the slots for the flap
hinges.
26 Rub a little Vaseline on the red leading
edges of the flaps to keep glue from sticking
them in place. Tape the flaps into position.
Use the hinges to mark the flap hinge slots on
the wing.
27 Cut slots in the wing for the flap hinges
and epoxy them into place. Note that hinge
with the horn goes on the inboard side by the
servo opening.
AILERONS
28 Remove the aileron hinges from the
ailerons and wing. Coat the centers of the
hinges with Vaseline to keep them from
sticking.
29 Glue the aileron hinges into the ailerons,
let the dry in the position shown to make sure
they are centered.
30 There are two faint marks molded into the
bottoms of the ailerons for the horns.
Highlight these marks and cut slots for the
horns.

JetLegend T-45 Goshawk Specifications

General

Brand	JetLegend
Model	T-45 Goshawk
Category	Toy
Language	English