J. California Proposition 65 Warning
This product contains chemicals, including lead, known to the state of California to cause cancer and birth defects or
other reproductive harm. Wash hands after use. §248224
Section II Introduction
This technical manual provides details of the set up and calibration procedures for the control as well
as providing information about the interfacing of the system with other 9700 series controls and
ancillary controls. It also provides troubleshooting and maintenance information.
The 9700W microprocessor controller has been developed to provide high quality, precision wire
feed control. The quality design and workmanship of this control will provide many years of
dependable service.
The 9700W control includes a motor controller and can therefore be connected directly to the wire
feed motor. It is used for motors up to ½ HP of the type used on Jetline standard wire feed. It
provides wire feed accuracy levels suitable for most conventional applications.
Modes of operation are:
Operator Mode:
This is the mode used by the welding operator to run the unit. It permits the wire feed speed , start
and stop delays to be adjusted.
Configuration Mode:
This mode is used to set up of the unit for specific applications. It permits the setting of the wire feed
speeds, and interface with other control boxes and features are used in a dedicated system.
Calibration Mode:
In this mode, the closed loop can be turned on and off, the unit can be set for inch or metric units and
the calibration can be checked and set.
To Next Page
Loading...
Need help?
General