10
Concealed connection
Important - For concealed connection any pipework external to the fireplace recess must be of the
sleeved type.
Hearth connection
Using 8mm pipe route this along the hearth. Ensure that the gas pipe does not interfere with the
removal or replacement of the fire front or operation of the controls.
Assembly of the fire bed
Carefully unpack the fire bed items:
- Rear coal bed.
- Front coal bed.
- Left hand side coal support.
- Right hand side coal support.
- Pack of loose coals.
IMPORTANT
Do not use the fire with broken or missing coals. Never add any extra coals above the
number stated in these instructions. This could cause a safety hazard. It is essential that the
coals are laid in accordance with the coal lay diagrams. Only the fuel bed parts supplied with
this appliance or authorised Jetmaster replacements must be used.
Coal Lay
Please note - These diagrams show the build up of a 16” fire. All other sizes should be treated in a
similar manner, merely adjusting the number of coals according to the width.
Rear Coal Bed
Place the rear coal bed onto the sloping face of the burner tray with the front edge resting against
the lip of the burner cap. Ensure it central left and right.
Front Coal Bed
Place the front coal bed in position on the burner tray in front of the rear coal bed. Ensure that it is
positioned behind the flanges on the edge of the burner tray and that it is central left and right. There
will be a gap between the rear of the front coal bed and the front of the rear coal bed.
Check that the pilot is not obscured and the front coal bed is flat down on the burner tray.
To Next Page
Loading...
Need help?
General
