17
2. If burner fails to light repeat operation 1 to purge any air from the system until the pilot and main
burner ignites. (Particularly if the fire has not been lit for some time, this will be necessary to
clear the air from the pipe and allow gas to reach the pilot burner.)
3. To turn down fire, point handset at sensor on the fire then push and hold the minus button (small
flame), the fire will give out a beep sound. If you release immediately the flame will go to low. If
you hold, the flame will lower slowly and you can release the button to your desired position.
4. To turn the fire up, point at the sensor, push the plus button (large flame), the fire will give out a
beep sound. If you release immediately the flame will go to high. If you hold, the flame will
higher slowly and you can release the button to your desired position.
5. The fire may be left in the standby mode (pilot only) by pressing the small round button on the
handset.
6. To turn your fire off, point the handset at the sensor and push the top left button marked Ɣ. The
fire will go out.
7. The fire has an additional safety OFF button. This allows the fire to be turned off in the event of
the remote control handset being lost or mislaid. The button is located on the right hand side of
the fire front control panel. (The ash pan cover must be removed first to see the button)
8. To turn off with the safety button. Remove the ash pan cover, then press and hold the black but-
ton marked OFF for 30 seconds. The fire will go out.
9. The fire can only be relit using the remote control handset.
10. If at any time the sequence will not start then press the off Ɣ button and restart at
operation 1.
Note:
1. The handset buttons need to be held for 1 to 2 seconds for the signal to activate the fire.
2. When the battery power is becoming low the beeping sound will continue every time you use
the fire, please contact your supplier to arrange for a new Lithium battery pack.
High Low
Off Pilot Only
Ignition —To light fire, push both buttons at same time
Cleaning instructions
IMPORTANT -
TURN OFF THE FIRE AND ALLOW IT TO COOL BEFORE COMMENCING CLEANING.
Cleaning the fuel bed
Note: Due to the fibre material used in the fuel bed it is inevitable that cleaning/replacement can be
a dirty and dusty operation. Suitable precautions should be taken.
1. Turn off the fire and allow to cool.
2. Carefully remove all the coals by hand and remove any soot deposits with a soft brush.
Do not wash the coals as this will cause damage. Do not use a vacuum cleaner.
3. Carefully replace the coals as described in ‘Coal lay’.
IMPORTANT
Do not use the fire with broken or missing loose coals, rear, front or side coal beds.
Never add any extra coals above the number stated in these instructions. This could cause a safety
hazard. Only the fuel bed parts supplied with the appliance or authorised Jetmaster replacements
must be used.
Fig 9
To Next Page
Loading...
