Jetson BOLT Guide

33
2.4 Tire Pressure & Inlation
BEFORE YOUR FIRST RIDE, YOU WILL NEED TO ADD AIR TO YOUR TIRES TO BRING THEM TO WITHIN THE RECOMMENDED
PRESSURE OF 35  40 PSI POUNDS PER SQUARE INCH. USE A GAUGE TO REGULARLY CHECK THAT THE TIRE PRESSURE
FALLS WITHIN THIS RANGE.
TO ADD AIR:
1. REMOVE THE DUST CAP FROM THE TIRE VALVE ON ONE WHEEL BY TWISTING IT COUNTERCLOCKWISE. SET ASIDE.
2. FOLLOW THE MANUFACTURER’S INSTRUCTIONS ON YOUR AIR PUMP TO INSERT AIR INTO THE TIRE. CHECK
PERIODICALLY WITH A GAUGE AND CONTINUE ADDING AIR UNTIL YOU REACH 35  40 PSI.
3. REMOVE THE AIR PUMP FROM THE VALVE AND REPLACE THE DUST CAP BY TWISTING IT ON CLOCKWISE ON THE VALVE.
4. REPEAT WITH THE OTHER TIRE.
IMPORTANT: ONLY USE A MANUAL AIR PUMP TO INFLATE THE TIRES ON YOUR BOLT. NEVER USE AN AIR COMPRESSOR;
DOING SO MAY CAUSE THE TIRE TUBES TO POP.
DUST CAP
TIRE VALVE

Jetson BOLT Specifications

General

Motor Power	350W
Charging Time	4-5 hours
Foldable	Yes
Motor	350W
Max Rider Weight	120 kg
Brake	Disc Brake
Tires	8.5 inches
Max Load	120 kg
Brake Type	Disc Brake
Top Speed	25 km/h
Weight	14 kg