IMPORTANT: HANDLE THE SEMI-ATTACHED HANDLEBAR WITH CAUTION. TAKE CARE NOT TO TUG OR TANGLE THE WIRING
CONNECTING THE HANDLEBAR TO THE FRAME.
1. PROP THE J5 UP ON ITS KICKSTAND. (SECTION 4.4)
2. LIFT THE STEM TUBE SLIGHTLY SO THAT IT IS NO LONGER TOUCHING THE FRAME BUT IS NOT FULLY UPRIGHT. DO NOT YET
CLOSE THE FOLDING LATCH.
3. PULL OPEN THE LATCH ON THE STEM CLAMP.
4. SLIDE THE HANDLEBAR STEM INTO THE STEM TUBE UNTIL THE "MINIMUM INSERTION" MARK IS NO LONGER VISIBLE ABOVE
THE STEM CLAMP.
TROUBLESHOOTING: IF THE STEM CLAMP OPENING IS TOO NARROW TO RECEIVE THE HANDLEBAR STEM, WIDEN THE CLAMP BY
TURNING THE CLAMP KNOB COUNTERCLOCKWISE FOR 1-2 ROTATIONS WHILE YOU HOLD THE LATCH STEADY.
2.2 Attaching the Handlebar
To Next Page
Loading...
