DUST CAP
TIRE VALVE
3.5 Tire Ination & Pressure
BEFORE YOUR FIRST RIDE, YOU WILL NEED TO ADD AIR TO THE TIRES TO BRING THEM TO WITHIN THE RECOMMENDED PRESSURE
OF 35 - 45 PSI (POUNDS PER SQUARE INCH). USE A GAUGE TO CHECK THAT THE TIRE PRESSURE FALLS WITHIN THIS RANGE
PRIOR TO EVERY RIDE.
TO ADD AIR:
1. REMOVE THE DUST CAP FROM THE TIRE VALVE ON ONE WHEEL BY TWISTING IT COUNTERCLOCKWISE. SET ASIDE.
2. FOLLOW THE MANUFACTURER’S INSTRUCTIONS ON YOUR AIR PUMP TO INSERT AIR INTO THE TIRE. CHECK PERIODICALLY
WITH A GAUGE AND CONTINUE ADDING AIR UNTIL YOU REACH 35 - 45 PSI.
3. REMOVE THE AIR PUMP AND REPLACE THE DUST VALVE BY TWISTING IT ON CLOCKWISE.
4. REPEAT WITH THE OTHER TIRE.
IMPORTANT: ONLY USE A MANUAL AIR PUMP TO INFLATE THE TIRES ON YOUR E-BIKE. NEVER USE AN AIR COMPRESSOR;
DOING SO MAY CAUSE THE TIRE TUBES TO POP.
To Next Page
Loading...
