3
18-R001/EN_FACTORY GP_part B
PLEASE KEEP THIS MANUAL AT A SAFE PLACE AND HAND IT OVER TO A
NEW OWNER IF YOU SELL THE JETSURF.
THE MANUAL COMPRISES OF TWO PARTS (Part A and Part B) which form
an integral document.
The rules and warnings included in one part apply also to the other.
Therefore always keep both parts with you.
SYMBOLS USED
This symbol is used to mark important warnings which are often
ignored by the JetSurf users. Please pay due attention to these
warnings. You will thus avoid making frequent user mistakes.
These warnings are based on the experience of the JetSurf servi-
ce technicians. Ignoring these warnings may cause permanent
damage to the vessel and its parts.
SAFETY WARNING SYMBOL
This is the safety alert symbol. It is used to alert you to potential personal injury
hazards. Obey all safety messages that follow the symbol to avoid possible injury
or death.
DANGER indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
WARNING indicates a potentially hazardous situation
which, if not avoided, could result in death or serious in-
jury.
CAUTION indicates a potentially hazardous situation
which, if not avoided, may result in minor or moderate
injury.
NOTICE is used to address practices not related to physi-
cal injury. This information could result in damages to the
product that are not covered under warranty.
These precaution icons will appear throughout the Owner’s Manual.
WARNING
CAUTION
NOTICE
TABLE OF CONTENTS
SYMBOL USED ................................................................ 2
SAFETY WARNING SYMBOLS ................................................... 2
ARRANGEMENT OF JETSURF AND IT’S ACCESSORIES IN BOARD BAG ................. 4
LIST OF ACCESSORIES ......................................................... 5
1B DESCRIPTION ............................................ 6
FUEL TANK .................................................................. 12
EXHAUST.................................................................... 14
CONTROL HANDLE............................................................ 15
ENGINE STARTER ............................................................ 17
IGNITION CONTROL UNIT (ICU) ................................................. 18
SIGNALLING OF IGNITION CONTROL UNIT (ICU) FAULTS ...................................20
INDICATOR ......................................................................... 22
ELECTRIC BILGE PUMP........................................................ 23
CARBURETOR................................................................ 24
CARBURETOR ADJUSTMENTS .......................................................... 24
PROCEDURE OF IDLE SETTING......................................................... 25
ENGINE ..................................................................... 26
2B SPECIFICATIONS ......................................... 27
SERVICE POINTS ............................................................. 28
To Next Page
Loading...
