JF C-40 S2 - Troubleshooting

10- Troubleshooting
Machine stuffing
Excessive volume of
gathered product
Turn the tractor off and turn
the pulley at the rear of the
machine counter clockwise,
expelling the product
excess
Excessive workspeed
Reduce the speed
Incorrect amount of knives
in the impellers
Install the correct amount of
knives in the chopping
impeller
Incorrect assembly of
knives in the impeller
Set the knives arrangement
Impeller`s knives are not
sharpened
Sharpen the knives
Impeller`s counter-knife is
not sharpened
Invert of replace the
counter-knife
Lower knife of the gathering
drums is not sharpened
Replace the knife
Loose transmission belts
Stretch the belt
Machine does not gather
the product
Safety pin(s) broken
Replace the safety pin(s)
Tractor horse power is
under specification
Use a tractor with power
according to indicated in
this manual
Tractor PTO speed is under
the recommended one
Use speed of 540 rpm
Cardan excessive vibration
Tail shaft is not counter
balanced
- Check whether the length
adjustment was correctly
done.
- Check whether the cardan
shaft is correctly coupled or
whether it is not “warped”.
- Check whether the joins
are aligned.
Problem
Causes
Solutions
54