JGaurora JGMAKER Magic - Printing Instructions and Operation; Main Menu and Control Panel

With User to Create Better Product
18
4, Printing Instruction
4.1 Main Menu Introduction
4.1.1 Control Panel
4.1.2 Function Introduction
（1）Main Menu：
（2）Preheat：Preheat PLA\Preheat ABS
⑧Adjustment knob
（Rotate Select, Press Ok）
④Speed Adjustment Ratio
⑦Hotbed Actual Temp.
⑨
Fan speed
③X/Y/Z Axis Coordinate
②Nozzle Actual Temp.
⑥
Hotbed Setted Temp.
①Nozzle Setted Temp.
⑩Print Progress
【Prepare】：Prepare works before printing，Include Move axis、Auto home、
Preheat、Cooling、Disable steppers、change filament etc.；
【Control】：Advanced settings，Include Temperature、Motion、Filament etc.；
【Print from SD】：Print model menu（ Shown as Print from SD Card after
insert SD Card or shown as No SD Card after SD Card removed.）；
【Preheat PLA\ABS】:Both preheat nozzle and hotbed，the corresponding temperature has been set in 【Control】；
【Preheat PLA\ABS END】：Preheat nozzle only；
【Preheat PLA\ABS Bed】：Preheat hotbed only；
⑤SD Card Status