With User to Create Better Product
4.3.2 Leveling
The first step: Firstly, we should screw all the four leveling nuts counterclockwise, then make leveling.
The second step: Press the control button into the main menu, select “Prepare” → “HOME”, press the button, the
extruder will go to the home place, find “ Disable steppers” in the same menu, now you could move the extruder and hot
The third step: After steppers stopped working, move the extruder to the four corners, then finish leveling.
When the extruder move to the relevant point, place an A4 paper on the platform, move the A4 paper and see the
distance, if the A4 paper is very loose and easy to move, then rotary the nut clockwise to close the gap, on the contrary,
if the A4 paper is quite tight to move, then rotary the nut counterclockwise to increase the gap, until the A4 paper has
a little scratch but no damage when moving, which means leveling finished.
Attention: Any question, please watch the video in SD CARD or consulting our engineers via email.
To Next Page
Need help?
General
