With User to Create Better Product
4.3.4 Model printing
The first step: Save the gcode file into the sd card of root directory(Details of slicing, please see the chapter 5).
The second step: Insert the sd card into the port of printer, when shows “ card inserted”, press the button and choose
the file you’d like to print, and make sure of it.
The third step: When temp. reached, printer will start to work automatically.
The fourth step: When model finished, display will show the tips of finished.
The fifth step: Take off the model, please keep in mind to take off the model when printer cooling down.
Attention: At the begging of printing, if the filament cannot paste on the bed, please make leveling again according to the
4.3.5 Filament Change
When printing, filament will be used up, it will need to change the filament as below:
（1）Press the button, select “tune”→ “change filament”, and confirm, wait the printer to pause printing.
（2）After printer paused, it will unload the filament, and shows “Wait for filament unload”.
（3）When unloading finished, display shows “Insert filament and press button to continue”, then insert the new
filament into the mouth and press the button to loading.
（4）When press load, display will shows“Wait for filament load”， until filament out of the nozzle, then select
“Continue” to quit filament change.
To Next Page
Loading...
