5.6 Connect the Camera by Search Nearby Devices
A
）
Connect the camera to the power supply and the camera would turn into self-test mode, which
would take about 15 seconds. Open the ‘CamHipro’ APP.
B） Add the camera by Search Nearby Devices follow the below steps.
Note:
1. Please make sure that the camera has been connected to router’s Wi-Fi.
2. Please make sure that your cell phone connects the same Wi-Fi as the camera connected.
3. If there is no camera on the device list, please come close to the camera and refresh.
Step 1 Step 2 Step 3
Step 4 Step 5 Step 6
To Next Page
Loading...
Need help?
General
