EasyManua.ls Logo

Jimi JV200 - Vehicle Oil Control; Oil Cut-off Functionality; Restoring Fuel Supply

Jimi JV200
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6.6 Oil cut-off
1. via platform
Send oil cut-off command on platform. To make sure the security of vehicle,
tracker can only indicate to cut off oil when GPS is in valid position status, and
the speed is less than 20KM/H or in static. Platform account password is needed
when sending oil cut off command.
2. Via SMS
Firstly, you should set a center number. Please refer to 5.4.
Only center number can send the command to the device to cut off and restore oil.
The format is: RELAY,1#
After the command is carried out, it will reply “Cut off the fuel supply: Success!
Speed:0 Km/h”. If the command didn't carry out, it will reply the reason about fail
to carry out.
To ensure the safety of the driver and the car, this command is valid only under
two conditions: the GPS is located; the speed is less than 20km/h
6.7 Restoring Oil
1. Via platform

Related product manuals