Need help?Do you have a question about the JL Audio Fathom f113v2 and is the answer not in the manual?
Visual guide for optimal placement of one or two subwoofers to manage room acoustics.
Recommends placement strategies for using two, three, or four subwoofers for improved bass response.
Detailed layout and labeling of all controls on the front panel of the Fathom v2 subwoofer.
Identifies and explains controls and connectors on the rear panel of f112v2, f113v2, and f212v2 models.
Specific layout and explanation of controls and connectors on the rear panel of the f110v2 model.
Explains the three positions of the Power switch (On, Off, Auto) and safe operation.
Details the Digital Automatic Room Optimization system, microphone input, and calibration process.
Explains the functions of the Demo, Defeat, and Calibrate buttons on the front panel.
Describes input mode indicators and the Level Mode switch for controlling output.
Covers the Master Level knob for volume adjustment and the Lights selector for indicator brightness.
Explains the LP Filter modes and the LP Frequency knob for bass crossover adjustment.
Details controls for fine-tuning extreme low bass, signal polarity, and phase alignment.
Details using XLR or TRS connectors for balanced audio input, offering superior noise rejection.
Explains using RCA connectors for unbalanced audio input, with optical isolation for noise reduction.
Describes rear panel switches for signal grounding and Master/Slave configuration for multi-subwoofer systems.
Explains the balanced XLR output for daisy-chaining multiple subwoofers in a Master/Slave setup.
Details the AC power connector, cord usage, and fuse replacement procedure for power issues.
Illustrates connecting a single subwoofer to a home theater receiver or preamp/processor via balanced or unbalanced inputs.
Details connecting multiple subwoofers in a Master/Slave configuration to a home theater system.
Demonstrates connecting a single subwoofer to a two-channel audio system, with or without an active crossover.
Illustrates connecting two subwoofers in stereo to a two-channel audio system for enhanced bass.
Outlines preparatory steps and initial settings for your receiver, processor, or crossover before subwoofer setup.
Guides through adjusting subwoofer level, polarity, phase, location, D.A.R.O. calibration, and ELF trim for optimal performance.
Provides steps to diagnose and resolve issues when the subwoofer produces no sound.
Addresses issues related to altered bass levels, hums, or other unusual noises within the system.
Offers solutions for bass that sounds muddy or too heavy, often related to room acoustics or settings.
Guides troubleshooting for D.A.R.O. calibration failures, including microphone and connection checks.
Provides advice for reducing sound leakage from the subwoofer outside the listening room.
Explains how to access, inspect, and replace the main power fuse in the subwoofer.
Provides comprehensive technical specifications for each Fathom v2 model, including dimensions and driver details.
Summarizes the main features and capabilities of the Fathom v2 subwoofer system.
To Next Page
General
