JL Audio MX600/3 - Page 7

Specications MX600/3
Rated RMS Power @
14.4V, <1% THD+N
Main @
4 Ω
Main @
2 Ω
Main @ 4 Ω
Bridged
Sub @
4 Ω
Sub @
3 Ω
Sub @
2 Ω
75 W x 2 100 W x 2 200 W x 1 250 W x 1 300 W x 1 400 W x 1
Rated RMS Power @
12.5V, <1% THD+N
Main @
4 Ω
Main @
2 Ω
Main @ 4 Ω
Bridged
Sub @
4 Ω
Sub @
3 Ω
Sub @
2 Ω
50 W x 2 80 W x 2 160 W x 1 200 W x 1 250 W x 1 300 W x 1
Frequency Response 20 Hz - 20 kHz (+0, -1dB), 6.3 Hz - 30 kHz (+0, -3dB)
S/N Ratio, A-weighted,
20 kHz noise
bandwidth
88 dB (Referred to rated power), 68 dB (Referred to 1 W)
Damping Factor >92 / 50 Hz @ 4 Ω, >43 / 50 Hz @ 2 Ω
Input Voltage Range 250 mV - 4 V (Low) or 580 mV - 14 V (High)
Input Mode Switch 2 / 4 Channel
Front High-Pass Filter Freq. Range: 35 - 300 Hz Slope: 12 dB/Octave
Sub Low-Pass Filter Freq. Range: 40 - 400 Hz Slope: 24 dB/Octave
Infrasonic Filter Freq. Range: 20 - 40 Hz Slope: 12 dB/Octave
Sub Output Polarity 0 or 180 degrees
Bass Boost EQ 0 to +12 dB @ 43 Hz
Remote Bass Controller M-RBC-1 or RBC-1 (sold separately)
Input Operating
Voltage
11 - 15 VDC
Min Power/GND Wire 4 AWG
Fuse Rating 60A
Dimensions 9.33 in x 4.50 in x 1.77 in / 237 mm x 114.5 mm x 45 mm