What to do if the Joerns Lifting Systems jack lowers with a patient suspended?
If the jack lowers while a patient is suspended, it might be due to the check valve not sealing properly. First, ensure that the pressure release knob is completely closed. Then, pull down on the boom a few times to try and reseal the valve. If the problem persists, the jack may need to be replaced.
Why Joerns Lifting Systems jack fails to lift to full height?
If the jack isn't lifting to its full height, it could be due to air trapped in the oil under the ram or low oil levels. Try pumping the unit as far as it will go, then open the pressure release knob and repeat this process until the lift reaches its full height. If that doesn't work, remove the jack, collapse the ram, remove the socket screw, and add hydraulic oil (#10 weight) one ounce at a time until full.
What to do if Joerns HML400 unit will not lower?
If the lifting unit won't lower, lay the jack on its side. Remove and clean the release cartridge, ensuring any small holes are clear using a pin or small wire.
What to do if oil leaking around rim of top cap in Joerns HML400?
If you notice oil leaking around the rim of the top cap, the jack needs to be replaced.
What to do if oil leaking from around piston in Joerns HML400 Lifting Systems?
If oil is leaking from around the piston, the jack needs to be replaced.
How to fix loose handle mounting holes on Joerns Lifting Systems?
To address handle mounting holes that are loosening or enlarging, periodically oil the pivot point.
Details base specifications including type for different models.
Specifies the maximum weight the lifter can safely support.
Outlines the vertical lifting range for the boom.
Lists the base width dimensions for different models.
Lists the base length dimensions for different models.
Provides the clearance height under the base.
Describes the finish material for various lifter components.
Instructions for attaching the cradle and swivel bar.
Specifics for attaching the swivel bar on C-HLA models.
Step-by-step guide on how to lift the patient.
Instructions for safely lowering the patient.
Checklist items for base and wheel inspection and maintenance.
Checklist for ensuring base locks and smooth operation.
Maintenance checks for the mast and its components.
Inspection of bolts, nuts, and centering of the boom.
Checks for wear on the cradle hanger post and sling attachments.
Inspection of swivel bar hook and associated washers.
Checks for pump seals, handle, oil leakage, and stud tightness.
Inspection of slings, web straps, and hardware for wear.
Details on parts warranty coverage and limitations.
Information on obtaining service and authorized technicians.
General| Brand | Joerns |
|---|---|
| Model | HML400 |
| Category | Lifting Systems |
| Language | English |
To Next Page
