The CVM controllers can be used as functional replacements for legacy N2 controllers. The N2-
capable MS/TP equipment controller models provide a cost-effective upgrade and modernization
path for customers with existing N2 controllers. For installation and commissioning support, and
tips for efficient and safe replacement, refer to the Modernization Guide for Legacy N2 Controllers
(LIT-12012005) and the controller-specific documentation. For information about mapping N2
Objects in controllers with switchable communications protocols, refer to the N2 Compatibility
Options chapter of the Controller Tool Help (LIT-12011147).
To configure CVM controllers to communicate using the N2 communications protocol, see
Configuring N2 communications.
The CVM controller can also be installed in a wireless application using anFX- ZFR/ZFR ProWireless
Field Bus Router. To configure these controllers to communicate using the wireless communications
protocol, see Configuring wireless communications.
North American Emissions Compliance
United States
This equipment has been tested and found to comply with the limits for a Class A digital device
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when this equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area may cause harmful
interference, in which case the users will be required to correct the interference at their own
expense.
Canada
This Class (A) digital apparatus meets all the requirements of the Canadian Interference-Causing
Equipment Regulations.
Cet appareil numérique de la Classe (A) respecte toutes les exigences du Règlement sur le
matériel brouilleur du Canada.
Installation
Observe the following guidelines when installing a CVM controller:
• To minimize vibration and shock damage to the controller, transport the controller in the original
container.
• Verify that all parts shipped with the controller.
• Do not drop the controller or subject it to physical shock.
Parts included
• One CVM03050 controller with removable terminal blocks (Input/Output, Power, FC, and SA bus
are removable)
• One installation instructions sheet
F4-CVM VAV Terminal Equipment Controllers Installation Instructions2
To Next Page
Loading...
Need help?
General
