Why doesn't the TEC3000 zone temperature change fast enough compared to a calibrated sensor?
If the TEC3000 zone temperature doesn't change fast enough compared to a calibrated sensor, it's because the TEC3000 is configured by default for larger spaces with normal-sized equipment when a proportional device is active. To resolve this, select 'Control Setup > Tuning > Equipment Size > Oversized'.
Why does the zone space temperature fluctuate too much in unoccupied mode on my Johnson Controls system?
If the zone space temperature increases or decreases too much when the unit is active in unoccupied mode, it means the heating and cooling equipment are too big for the unoccupied space. Decrease the 'Unoccupied Off Delay' parameter from 10 minutes to a more appropriate time for the equipment configuration.
What to do if Johnson Controls Controller provides an error when trying to back up settings?
If your Johnson Controls Controller provides an error when trying to back up settings, it means the USB drive is defective. Try a different USB drive.
Why does my Johnson Controls TEC3022 provide an error when trying to restore settings from a backup?
If your Johnson Controls Controller provides an error when trying to restore settings from a backup, it could be due to several reasons: * The USB drive is defective. Try a different USB drive. * The restore file is corrupt. Try restoring a different backup file. * The restore file is from an incompatible model TEC. Ensure that the backup file being restored was from the same model TEC.
What does the Bell icon on my Johnson Controls TEC home page mean?
If the Bell icon is displayed on the TEC home page, it means a fault has been detected on the TEC. See Table 12 for TEC fault causes and resolution.
Describes networked/wireless models, occupancy sensing, touchscreen UI, fan configs, and dehumidification.
Steps for removing cover and mounting the base.
Describes terminal labels and their functions for various models.
Steps for updating firmware and backing up settings.
Procedures for restoring settings and configuring network communication.
How to reset screen and choose between 2-pipe, 4-pipe, or VAV configurations.
Setting control modes and fan parameters.
Configuring VSF, control modes, and fan operation.
Procedures to reset and disable PID tuning parameters.
Faults and solutions for zone, supply, and outdoor temperature failures.
Faults and solutions for internal sensor, dehumidification, service, and calibration issues.
Faults and solutions for open window, fan lock, humidity, and controller errors.
Faults and solutions for touchscreen, board mismatch, firmware, USB, and runtime issues.
Symptoms, causes, and solutions for cooling/heating unavailability and cycling.
Issues with firmware upgrades, temperature response, and unoccupied settings.
Issues with settings backup, restore, and USB access.
Issues with unresponsive touchscreens, hidden icons, and network connectivity.
General| Model | TEC3022 |
|---|---|
| Product Type | Temperature Controller |
| Supply Voltage | 24 VAC/VDC |
| Communication Protocol | BACnet MS/TP |
| Number of Inputs | 2 |
| Number of Outputs | 2 |
| Control Algorithm | PID |
| Display | LCD |
| Enclosure Rating | IP20 |
| Mounting | Wall Mount |
| Type | Thermostat |
| Controller Type | Digital |
| Application | HVAC |
| Input Type | Thermistor |
| Output Type | Relay |
| Power Supply | 24 VAC |
To Next Page
