TW 2, 3, 4
0630
0620
TW 1
4.6.4 Disassembly of shaft arrangement
1. TW1
Bend the tooth straight out of the groove
of the nut and remove the locking
nut (0620) and remove it.
1. TW2, TW3, TW4
Loosen set screws of locking nut (0620)
and remove it.
2. Support the bearing holder on mounting
surface and press the internal ring of
bearing (0701) together with the shaft and
bearing (0700) out of the bearing holder.
Ensure that the mounting surface of the
bearing holder is not damaged.
3. Remove the bearing holder with external
part of bearing (0701) and the external
ring of bearing (0700) from the shaft.
4. Remove the external ring of bearing
(0701) from the bearing holder (0121).
5. Remove the internal ring of bearing
(0700) with rollers from the shaft.
6. Do the same for the second shaft.
To Next Page