©2015 Johnson Level & Tool 27
• If the unit will not take a charge, does the battery charger LED light
change to red as soon as it is plugged in? If no, it is most likely an
issue with the charger. If the unit is within the warranty period,
contact Johnson Level & Tool’s customer service department to
request a replacement charger under warranty. If the unit is not
within the warranty period, go to www.johnsonlevel.com to
purchase a new charger. If yes, contact an authorized Johnson
service center or Johnson Level & Tool’s customer service
department.
• If the unit will not calibrate, contact an authorized Johnson service
center or Johnson Level & Tool’s customer service department.
• If the unit beeps and/or flashes constantly, check to see if the unit
is being tilted to angles beyond the self-leveling range. If the unit is
being used for a level application, place onto a surface that is
within the self-leveling range. If it is still beeping and/or flashing,
the unit is out of calibration.
8488H-English_Manuals 11/11/14 2:37 PM Page 27
To Next Page
Loading...
