POLY V BELT400/380J6 REPLACEMENT PROCEDURE
Tools required:
Philips screw
driver
Hex key (4mm)
Crank extractor
Coin
Open-end wrench
(14&17 mm)
Procedure:
1. Remove the crank cover and screw, then remove the
crank. Loosen the screws from the side cover with
the screwdriver, then remove the footpad, guard and
side cover.
2. Loosen the 400 J6 and 500 J8 belts.
3. Loosen the screws from the front pulley by using
the hex key (4mm), then remove the front pulley
4. Replace the 400(380) J6 belt with a new one.
5. Tighten the
screws from
the front
pulley by
using the hex
key (4mm).
6.
front and rear pulleys.
7.
and the
parts.
Install 400(380)
J6 and
500(440) J8
belts onto the
Install the side
covers
To Next Page
Loading...
Need help?
General
